OpTaliX Version 11.50

Changes to version 11.50:

Determination of higher modes in calculating the fiber coupling efficiency (CEF) corrected. The problem occurred only in multi mode fibers. Calculation using mono mode fibers were not affected.

The fiber types OM1, OM2, OM3, OM4, OM5 according to the ISO 11801 standard have been added to the fiber catalogue.

Export to Code V: Sign of pickups if surface parameters are inverted now correctly written.

The field aberration plot (FIE command) failed if positive and negative field values were simultaneously specified.

Sumita and CDGM glass catalogues updated.

The SAG command applied to Fresnel surfaces returned incorrect values: Instead of the actual step-like form the sag of the base surface was returned. Now corrected.

The calculation of glass internal transmission could fail under very rare conditions. Now corrected.

Thin film calculations in non-sequential surface ranges improved. Previously the substrate index was not always correctly applied.

Minor changes.