OpTaliX Version 11.00

2021-07-19 15:07:10

Changes to version 11.00:

The interpolation of two-dimensional surface deformations (imported via INT files) has been significantly improved, in particular when the deformation contained very steep slopes.

A scaling problem in the "RAW2INT" command fixed. It was created by an inappropriate conversion of raw values to integer numbers in the INT file.

The program did not make use of multiple processors (if existent) but run in single processor mode instead. This effect was erroneously introduced. Now fixed.

The ray grid size (NRD = number of rays across diameter) can now increased to 2048 x 2048 rays to allow modelling of very fine structures in the entrance pupil.

The lens databease item [ABBE] now correctly accounts for dispersion offsets (DVO), if existent. Previously only the fixed abbe number of the catalogue glass was reported.

OHARA i-line glasses added to glass catalogue.

Minor changes.